Kalanution 2pcs Cooling Blower Fan DC 12V 0.15A 50mmx15mm Fans for 3d Printer Humidifier Aromatherapy and Other Small Appliances Series Repair Replacement

Cooling Blower Fan 12vdc 0.15A 50mmx15mm Widely used in humidifier, aromatherapy and other small appliances series; small heat radiating communication equipment; military equipment; intelligent industrial control equipment plate cooling heat, high precision medical equipment cooling; pc cpu server cooling dissipation and so on—Repair Replacement (2Pack)
Type: Centrifugal Blower Size : 50 * 50 * 15mm
Bearings: Oil
Voltage : 12V
Current : 0.15A
Scope: humidifiers , heaters, clothes dryers , etc.
Quantity:2Pc
Noticeļ¼š
This product of our company are non-waterproof product, it is strictly prohibited using in the water. Secondly, product operating voltage is DC12V, prohibit overload use.
Product working environment is below zero 10 Degrees Celsius to 70 Degrees Celsius Fourthly, please do not dismantle the product privately.

Product Features

  • DC 12V 50mm Blower Cooling Fan Hotend Extruder Turbine Fan for 3D Printer
  • Total Size : 5 x 5 x 1.5cm /2″ x 2″ x 0.6 ” (L*D*H); Outlet Size : 2 x1.5cm/0.8″ x 0.6″(L*W) Cable Length : 25cm/9.8″; Mounting Spacing : 5.8cm/2.3″;Weight : 26g
  • Brushless Fan,DC Blower Fan,Brushless DC Blower Fan,50x50x15mm Fans
  • Guaranteed to continuously run 10,000 hours under normal temperature. Speed: 5200 RPM
  • Cooling Blower Fan 12vdc 0.15A 50mmx15mm Widely used in humidifier, aromatherapy and other small appliances series; small heat radiating communication equipment; military equipment; intelligent industrial control equipment plate cooling heat, high precision medical equipment cooling; pc cpu server cooling dissipation and so on—Repair Replacement (2Pack)

2 thoughts on “Kalanution 2pcs Cooling Blower Fan DC 12V 0.15A 50mmx15mm Fans for 3d Printer Humidifier Aromatherapy and Other Small Appliances Series Repair Replacement”

  1. Had to replace and resolder the wires with better quality wires The solder at the fan side will come off eventually. Just used it for few weeks on my 3D printer. Had to replace and resolder the wires with better quality wires.

Leave a Reply

Your email address will not be published. Required fields are marked *

two × 4 =